Transformer oil regeneration plants

 

Transformer oil regeneration plants

Fuller’s earth oil regeneration plant CMM-R

Comparing to older technology where Fuller’s Earth is used only once and then must be disposed of together with oil and harmful contaminants, CMM-R plants utilize the principle of sorbent (Fullers Earth) reactivation and have a number of unique features

 

Transformer oil regeneration plants

Oil regeneration plant UVR

Mobile oil reclamation units are categorized according to their
regeneration process:

  • mobile oil unit СММ-R (UVR) – for oil regeneration by means of whitening argils with the following filtration;
  • mobile oil unit СММ-R (URМ) – for oil regeneration by means of whitening argils with the following filtration;
  • mobile oil unit СММ-R – for oil regeneration by means of whitening argils with the following sorbent reactivation.
 
Transformer oil regeneration plants

Zeolite&silicagel oil regeneration plant CMM-Z

The unit may be used for installation, repairs and operation of oil filled high voltage equipment with the voltage no more than 1150 kV (power transformers, high voltage switch gears etc)

 

Transformer oil regeneration plants

 

 

Single section oil reclamation plant MCU

Mobile oil recycling station CMM-U is designed for purification of insulating oils from mechanical contaminants, water and acid. Oil viscosity should not exceed 70 cSt under the temperature of 500 C. This oil treatment unit can be used while assembling, maintaining and service works of oil-filled high-voltage equipment (such as power transformers, high voltage switches, turbines etc.) of less than 1150 kV voltage.

 

Transformer oil regeneration plants

 

 

Adsorbent reactivation and preparation unit BRPS

The BRPC plant (adsorbent reactivation and preparation block) is designed for adsorbent steam washing, moisture removal off the adsorbent by means of thermal desorption enabled by especial electric heaters as well as adsorbent vacuumizing.

 

Transformer oil regeneration plants

 

 

СММ-4RP Sorbent Reactivation Unit

Sorbents in use gradually lose adsorption capabilities and reach an equilibrium, when the adsorption process stops entirely. In this case, the sorbent must either be replaced or reconditioned. The latter option is preferable, reducing the cost of procuring new and disposing of the old sorbent, as well as cutting transportation expenses. To solve task of waste sorbent reactivation, GlobeCore has developed the СММ-4RP unit.